Home 

Ref-Wiki.com -

BLOG
Blog
Some fields of solar energy
, Because no life could exist on earth without the sun's energy, solar energy, is as old as life. Even centuries ago residential premises were often built to take advantage of the warmth of the sun. Dried fruits and other food and water evaporates from brine, to leave Sol. Earlier in the twentieth century, solar collectors were used to heat domestic hot water. As a sharp increase in the cost of energy from fossil fuels in the mid-1970s and prospects of further growth of solar energy has become a subject of particular interest as one of renewable resources. ....
 
When to use a cooling tower
performance advantage of cooling towers and evaporative condenser is that the condensing temperature can reach ambient temperature wet-bulb temperature. Because the wet-bulb temperature is always equal to or less than dry bulb thermometer temperature in the cooling system can work with below the temperature of condensation and thus energy savings compared to air-cooled condenser. The absence of cooling tower that maintenance costs tend to be higher than for an air-cooled condenser and attention must be given to preventing the water from freezing in the cooling tower if surgery is necessary in cold weather. ....
 
Types of heat pumps
All refrigeration systems and heat pumps, as they absorb heat energy at a low temperature, level and flow of water at high temperature. Designation heat pump, however, has developed around the use of the cooling system where the heat rejected at the condenser is used instead of simply being dispersed in the atmosphere. There are certain applications, and cases when the heat pump can be useful cooling and useful heat output, and it certainly is a winning situation. ....
 
Capillary tubes
capillary tube serves almost all small refrigeration systems and its scope covers the refrigerating capacity of 10 kW. Capillary tube from 1 to 6 m with inner diameter, usually from 0.5 to 2 mm the Name is a misnomer, because suffered too large to allow the capillary effect. Liquid refrigerant enters the capillary tube, and as it flows through the pipe, the pressure drops due to friction and acceleration of the refrigerant. Some liquid flashes into steam, refrigerant passes through the tube. ....
 
How the various types of compressors share the field
four types of compressors studied in this Chapter, piston, screw, vane, and centrifugal, all were somewhat different qualities, so that for each type found application in areas where it has advantages over others. A fairly accurate statement, in which compressors can be used based on their cooling capacity. Piston compressors dominate with a very small cooling capacity of 300 kW. Centrifugal compressors are the most widely used for refrigeration units with a capacity of 500 kW and above. Screw compressor has found its niche in the 300-500 kW of power and competes from large reciprocating compressors against small and centrifugal compressors. Compressor blades competes with reciprocating compressors, primarily, on the market of household refrigerators and air conditioners. ....
 
Hermetically sealed compressors
compressor, whose cranked shaft passes through the compressor casing so that the engine can be externally connected with the shaft is called open-type compressor. The seal shall be used in cases where the shaft comes through the compressor housing, to prevent leakage of refrigerant gas or air leakage in the case of a crankcase pressure below atmospheric pressure. Although designers are constantly developed better, seals, piercing accommodation is always a source of leakage. To avoid leakage print engine and compressor often enclosed in a single package. ....
 
Types of compressors
Each of the four components of the steam-compression systemcompressor, condenser, expansion unit and the evaporator has its special behavior. At the same time, each component is influenced by the conditions imposed by the other members of the " Quartet". Changes in the condenser-water temperature, for example, may change the rate of refrigerant in the compressor, pumps, which, in turn, may require the expansion valve, how to rebuild and refrigerant in the evaporator pressure changes. We must study the components of the vapour-compression cycle alone, the analysis of their efficiency as individuals, and then observe how they interact with each other as a system. Compressor first component analysis. ....
 
<< Start < Prev 1 2 3 Next > End >>

Page 2 of 3
Thanks ->



Chiller Direct refrigeration system External equalizer Forced lubrication method High side float valve Hot air furnace wiring diagram Low pressure chillers Multi stage refrigeration system Potential relay and current relay R404a wiki R407c vs r134a Single screw compressor Two stage cascade refrigeration system
Copyright @ 2009 - 2022, "www.ref-wiki.com"