EnglishFrenchGermanItalianPortugueseRussianSpanish
Hermetic Compressors: Refrigerator compressor parts of Compressor
Home 

Refrigerator compressor parts of - Refrigerator compressor

Technical information Compressors Hermetic Compressors

Hermetic Compressors

Hermetic compressor directly to the compressor with direct connected motor compressor Assembly has the steel case. It is designed for pump low pressure refrigerant gas high pressure.

Pressurized container, tightly closed so that no gas or liquid may enter or escape. Welding container seal.

Hermetic compressors Tecumseh low pressure shell, or housing. This means that the interior of the compressor housing is regulated only suction pressure. He is not subject to discharge created with the help of the piston. This point is emphasized in order to emphasize the danger of introduction of high-pressure gas compressor shell pressures over 150 pounds per square inch.

Major of internal parts hermetic compressor are shown in Fig. 9-10. The suction is drawing in the compressor shell and then by an electric motor that provides power to the crankshaft. The crankshaft rotates in bearings, the movement of a piston or pistons in цилиндр or cylinders.

The crankshaft is designed for transportation of oil from the oil pump at the bottom of the compressor for all bearing surfaces. REFRIGERANT gas surrounds the crankcase of the compressor and motor, as it passes through the compressor shell and the cylinder, through the suction muffler and suction valves. The gas is compressed pistons, and went out through a pressure relief valves silencer, and the compressor discharge tube.

..

 
Thanks ->



Absorbent refrigerant combination Ammonia pipe sizing Approach temperature Bare tube evaporator Cooling and dehumidifying coils Copper pipe sizes inches to mm Evaporator construction Finned tube evaporator Oil safety switch Oil separator in refrigeration cycle Plate and shell heat exchanger Refrigeration load Setting epr valve
Copyright @ 2009 - 2017, "www.ref-wiki.com"