Remove Hermetic Compressor

1. Disconnect the electrical circuit.
2. Install the sensor manifold. Use a piercing valve in case of need.
3. Recovery of refrigerant.
4. Disable lines. Put on your glasses!
• A. Clear and suction and discharge pipe on the straights near the compressor. Use a pipe cutter. Connect the line immediately.
• B. Clean the pipe or valve on the compressor. Put soldering flux. Warm joint and pull the pipe. Plug the holes immediatel.
5. Remove the motor-compressor.
6. If the compressor engine has an oil cooler lines, they should be pinched, then cut pipe cutter. Compressor pipes openings should be closed.