There are several uses for solvents and detergents in the normal maintenance schedule air cooling fin condenser coil, and an evaporator coils standing type air filters and fan blades. In most cases, a high-pressure spray washing machine is used for equipment cleaning and detergent. Then a high-pressure spray washing is used to clean the device, wash. The pump is usually rated at 2 gallons per minute of 500 pounds per square inch of pressure. The main function is to remove dirt and grease from the fans and the cooling surfaces. It takes about 10 to 15 minutes for washing solution to do their job. Then rinse with clear water.
Use the method of spraying cleaning permanent types of filters. Prepare wash solution from one part of cleanser to one part water. To use this solution as a bath in which the filters can be submerged in water for a short time. After the dive, you can install the filter in the direction from 10 to 15 minutes. Rinse under running water. If there is no water, good results can be obtained by a lively campaign in the tank with fresh water.
When draining the solution used when cleaning, make sure to follow local rules on the use of stormwater for recycling.
Correct disposal of waste solution is critical for the legal operation of this type of air conditioning.
Another new requirement is the use of asbestos in the construction of the tower fill. If we learn when checks are carried out, ensure that it is replaced with modern materials. The old tower can be more efficient with new fill more modern design. Cooling tower manufacturers design their units for this performance standard for conditions such as the type of cooler is used, the environmental temperature, location, technical characteristics.
As the system ages, it can lead to a loss of efficiency. Cleanliness of the tower and its components are key to the success of the system. Automatic cold water, the temperature will rise. This would send warm water for cooling. When the chiller is driving at high head pressure, the system may shut down. Certain precautions should be taken to prevent the disconnection occurs...
Industrial