Индикатор стакла / влаге

Each field rechargeable system must have a means to verify the sufficient amount of the refrigerant. Correctly located sight glass meets this need. It will not, however, tell you if the system is overcharged. Sight glass should have a viewing window on either side (dual port), so a flashlight may be shone through the refrigerant. In addition, sight glass should have a seal cap on every port to prevent leakage.

Sight glass can be included in the original equipment. The split-systems and embedded systems, it must be installed as a refrigerant accessory. Correctly located sight glass is helping with the charging system. The usual location for sight glass on the liquid line as close as possible to the receiver outlet, or the кондензатор outlet, if the receiver is not used.

In systems with liquid lines of moderate length, and a few accessories to cause the liquid line of the fall, more convenient location, you may be just upstream from the liquid metering device. In this place, sight glass has an additional function, which shows a pure liquid enters the metering device, as it should. When the pressure drop of the condenser (or AV receiver) with a уређај за дозирање is substantial, additional sight glass must be installed capacitor (or receiver) at the output. The nearest евапоратор indicates the pressure drop in liquid line.

When the charge is correct, but the bubbles appear before the metering device, it means the flashing occurs in liquid line due to pressure drop. This situation can be eliminated by reducing the pressure drop for further subcool fluid...