Floors
Heavy floor loads and the use of a ride on the electric demand is strong, hardworking floor surface, which must be in isolation envelope. Floor construction begins with solid concrete Foundation slab about 200250 mm at the bottom of the last floor. This is covered with a barrier, perhaps overlapping layers thick-walled polyethylene sheets. It is placed on the insulation Board in two layers with a shift of the welds; this is fitted as closely as possible. Building bitumens of paper to be used for surface coating and prevention of penetration into isolation joints on the tiles of the floor.
Concrete floor itself, reinforced steel mesh and put in the sections to enable compression cooling. It can be placed in strips length up to 100 m and were subsequently cut when partially cured. In cuts usually under the shelves to avoid seams on the truck the way. As gender is compressed, open cuts and, finally, can be filled with hard setting mastic.
The need for good design and expert installation of floor coverings is impossible not to pay attention.
Floor gets the highest wear all internal installation, and when the temperature was reduced in the repository, it normally will remain low throughout his life. Repair of damaged floors require the use of low-temperature epoxy resins or low temperature cement mixtures.
Where such a shop, to take the post-pallets, or have internal shelves for storage of pallets, a careful calculation of the load of your feet. They can have a significant point of load, having the effect of punching through floor finish...
|
Cold storage