Home 

Ref-Wiki.com -

Technical information Condensers and cooling towers Other forms of condenser

Other forms of capacitor

In the cascade system, higher stage evaporator, condenser at a low speed. The construction of this heat exchanger is a combination of design factors for evaporators and condensers, and not General rules apply in addition to these. The intercooler in two stages or composite systems-de-superheats the utilization of gas from the first stage, so that it will not be too hot for receipt in higher stage of development. In practice, this will leave the intercooler only slightly superheated through intermediate point of saturation. Normal variations in the operating system may lead to actual condensing at times, but it was not intended.

Small surface condensation necessary household appliances such as deep freeze may allow the use of outside the metal skin of the device, as the surface of the condenser. In this design, the condenser tube is carried out in close mechanical contact with the skin, so that the heat is transmitted through the open air, where he lost by natural convection. This system is limited to a few hundred watts.....

 
Thanks ->



Chiller Diurnal variation of relative humidity External equalizer Forced lubrication method High side float valve Hot air furnace wiring diagram Low side float valve Potential relay and current relay R404a wiki R407c vs r134a R717 refrigerant color code Single screw compressor Two stage cascade refrigeration system
Copyright @ 2009 - 2022, "www.ref-wiki.com"