Početna 

Bellows type thermostat - Bellow thermostat

Техничке информације индустријски Bellows-type thermostat

Membrane-type thermostat

Modern condensing units, low-pressure control switches are largely replaced by thermostatic-control switches. Thermostatic consists of three main parts: a bulb, capillary tubes, and a power element or switch. Lamp is attached to the evaporator in a manner that ensures contact with the евапоратор. He may contain volatile liquids such as refrigerant. Lamp is connected to a source element with a small капиларна цев (see Fig. 14-13).

The work of the bellows is provided by the temperature change. Or thermostatic switch management, such as increased temperature of the evaporator, bulb temperature also increases. This raises the pressure thermostatic-liquid pairs. This, in turn, causes bellows expand and intensify the electric contact. Contact closes the circuit of the engine, and the engine and compressor will start to work. As evaporator temperature decreases and the lamp becomes colder and the pressure is reduced to the point where bellows contracts enough to open the electrical contacts, so turning off the motor circuits. Thus, the condensing unit is fully automated. Thus, it is able to produce as much cold required to meet any normal operating condition.

..

 
Хвала ->



Величина амонијачне цеви Типови компресора Цср дијаграм ожичења компресора Прорачун експанзијског вентила Халидска бакља Закони хлађења ПХ дијаграм Плоча и шкољка измењивач топлоте Притисак који ограничава ткв РКСНУМКСа табела температуре притиска расхладног средства Врсте расхладних уља Хладно оптерећење Пренапонски пријемник
Цопиригхт @ КСНУМКС - КСНУМКС, "ввв.реф-вики.цом"